Nistune Forums

Hmm that's odd that it still doesn't work even though the fix was done before that, Do you have any suggestions I can tell the dealer or parameters that need to be enter rb20for25 ac vct manual is the map I use to get the vct light to illuminate

nope it wont show in either, I have two boards swapped one another out and neither would work. I had them flashed around august 2018, do you know if the fix was after this or before it, just curious thank you for your help

So i did make sure all those channels are ticked when i connect, vct still activates but their is no light, im guessing i have to get my board re-flashed??

I have the board setup for ac out, light still doesn’t work I am going to send it back to the distributor and have him flash it again.

Matt wrote: ↑Wed Jul 31, 2019 12:28 pm Also make sure in Consult Channels Digital Control register 1,2 and 3 are enabled. If older firmware, reflash the board with what I attached

what exactly do you mean enabled ? where do I do that?

the a31 file for rb25 will work on my hcr32?

ok I verified I have latest and I still don’t get it to light up, it clicks but does not light up ?

I believe I am running the latest firmware, I am going to try and start fresh and just copy over my tune, maybe that will help, Worse case it works and the light doesn't activate no big deal, thank you for your quick reply as always. I am loving the new gauges and such!

I recently had the ecu pinned bridging the a/c 9 to pin 113 to activate the vct on my rb25det neo, I have it successfully activating( cut) @ 1100 and recover at 5900, my questions is that on the consult view the vct never shows it activating even though mechanically it will with no issue, not sure i...

You're very welcome!

I recently had an issue with my ecu that was nistuned, I used it for over a year and loved it. I had an issue finding another stock ecu so I jumped the gun an bought a Haltech plug and play (1300usd).It showed up and I plugged it in, got the car running after a bit of research. Throughout using it, ...

That would be cool, however I think its just not worth it, Sensor barely fits and requires a tad more work and seems to be very touchy from my experience. Could have been that leak as well but looking forward to upgrading to better platform 3" or 3.5".

Spoke to pmas directly, It is designed that way to prevent corrosion. However now that i moved on from that, I decided to do another boost leak test to make sure nothing else was leaking, I found that there was a pin hole in one of the welds directly where the mas sits, Well i think this is positive...

Sorry I couldn't post the bin, I was at work and didnt have access to it. But will include it in this post. So i tried a few things today and seemed to have better luck. 1.Loaded new map from start 2.Changed maf with vq generator 3.changed injectors from 380-550, unticked tim and unticked crank 4.Ma...

I have been going back and fourth sometime now trying to figure out this cold start issue, It will crank and crank and then it will eventually start and the afrs go from about 9.0 up to 14.7 and will stay running without an issue. Almost immediately after I shut the car down (even when warm) and try...