Nistune Forums

Hi all, i'm struggling with the Type 1 Board Driver install under Win10 x64. Tried multiple times with both the Nistune Test Version and the official Release. Always getting the following Warning in the Device Manager: Windows cannot load the device driver for this hardware. The Driver maybe corrupt...

Thanks mate, you're the man!

@ Matt or anybody who can help: Is there any kind of transient enrichtment for the CA18DET EDM ECU?
My calibration is spot on steady state but quick throttle opening causes a short lean spike, nothing drastic but it would be nice to deal with it via transient fueling.

Thanks

Hi Matt,

sorry to Hijack this thread but how far are you with the Firmware update that will enable Cyl Selective Knock Logging?

Thanks in advance
Felix

I did some more measurements today at 2500rpm, 3000rpm and 5000rpm and the Stock ROM will adjust the Dwell to 1.75ms throughout the Rev Range.
My plan now is to adjust the base "Dwell Time" Table and scale the Dwell Duty at idle rpm down to avoid overheating the Coils.

First Part of Dwell Time Measurements: Today i finally got my measure setup in the car complete and could measure the stock dwell time for the EDM CA18DET ECU. I used the quickest Sample Rate available at 0.1ms and measured at 850rpm in Idle. I'm going to measure all other rpm's in 500rpm increments...

Yeah just hold off for that then. I don't have an ETA unfortunately as I'm finishing up FP1.1/FP2.1 for SR20DET currently (half way updating my patching scripts), and then will go back to the knock count work after that Hi Matt, any update on FP1.1 re-release with cylinder selective knock count for...

Hi Matt,

no worries i was super busy as well and didnt even had the time to check until now.
Works perfectly fine.

Thanks
Felix

Hi Matt,

i'll wait, your Friday is my Thursday anyway

Hi Matt, thanks for the reply. Hi Felix Are you opening the file directly, or just putting it over the top of the previous one in your Documents/Nistune/Address folder? You should just replace the previous version Tried both, if i replace it and go to Select Vehicle -> S13/RS13U12 Silvia/180SX CA19D...

Hi Matt, it shows: Errors in Adress File cannot process! Error: ROM OFFSET is not specified Error: ROM ORIGIN is not specified Error: ROM LENGTH is not specified Error: CPU type is not specified. All in one Error box. Also: How can i open the Consult Ram Tracer with a Type1 Board that has no consult...

Awesome Matt,

thanks a lot for putting so much work into this!

When i try to load the adr file you just posted it gives me an error. Let us know when the official re-release of the CA18DET V1.1 is done

Yeah just hold off for that then. I don't have an ETA unfortunately as I'm finishing up FP1.1/FP2.1 for SR20DET currently (half way updating my patching scripts), and then will go back to the knock count work after that Hi Matt, just to clarify: In the current V1.1 the Knock count works but is not ...

Thanks Matt, i tried it yesterday by just "spreading" the top third of both maps to reach TP 100 instead of 83 and there seems to be no problems so far.

Thanks Matt! You mentioned that you're going to update the FP1.1 again to have cylinder based knock counts, do you have any ETA on the release of that update? Just contacted a workshop in Germany to check if they have the base image programmer and i don't want to flash the new .ent before these chan...