Nistune Forums

Can you please make the Input Tracer Window size adjustable, my eye's can't cope with the fixed size any longer

Using Zeitronix unit the boost display in log player is to low to view correctly

Yea he has a good rep for sure, I think he just hasn't had much experience with factory ECU, he did my Nistuned R32 years ago which went very well afterwards.

Either take it back to Sochi and get him to read up and view the comments here or see if Torque Performance will do it.
Address:37 Patiki Road, Avondale
09 828 7054

When it happened to me, everthing was fine it was just a display thing, the car ran the same without any issue.

I had this happen once, many versions ago.
Switched everything off and back on and all was fine.
I considered it a one off kind of thing.

Ok this car has issues. Not long ago it idled and ran very smoothly now most of the time it idles like crap, especially when cold it won't idle until you hold the revs for a few seconds and your lucky. When you come to a stop it surges a bit like you pushing the gas, sometimes quickly stabilizes som...

Sadly I think Stu is not well

When my plms consult cable is connected to consult plug only and not laptop there is no power light at all, the 12v led is only for USB 12v supply.
Double Check for 12v between gnd and 12v pin on consult plug in above pic.

"Thanks guys, I ended up going for the Rochester 1000cc low impedance injectors."

Don't forget the resistors!

r32 ECU will not kickdown based on TPS, its different to r33 ECU
I just manualy change down when the time is right, like you would have to in a manual.
One option is to get Skyline Stu's r33 ECU setup

No bin/image file is loaded?

It seems the sample rate of the Zeitronix is not fast enough, requires 10khz minimum.

No sorry i have no specs, from what i understand its a 0-4.5v output for logging.

this is the contact page

http://gizzmousa.com/contact.asp

"aftermarket knock control module like the Gizzmo"

Yes Gizzmo has two 0-5v analog outputs, what is required to do this Matt?