Nistune Forums

Thanks Matt!!!

What do you think about this scenario with the <currentuser>: User1 = Admin User2 = Standard user Installs Nistune logged in as User2 and the translation files then ends up in "User2/Documents/Nistune/Translation". If I then log in as User1 do I need to manually copy the translations from ...

Hi, I have two user accounts on my everyday PC. One admin account and on standard user(not admin) and I always run everything as the standard user for an extra layer of safety. When I ran the NIStune and ROM installation on this PC I pushed "next, next, next" as always :roll: it then place...

How is the "Volt Latency Change" behaving according to the volt?

My injectors has an average latency change of 44,33 ms per volt.
Is that what I should sett the "Volt Latency Change" to?

Thanks for the tips!

I have started to check all the grounds but they are all fine so far.
I have also tested to play around a bit with voltage latency but that didn't seem to help me.

Hi! I have a wierd problem with my car. When I start stuff that adds load on the generator (like high beam, fans in full speed, rear windscreen heater....) the engine runs rich. I can see this both on my VEMS wbo2 and from the sound and feeling of the engine. My AFR is "perfect" until my e...

Thanks Matt! I was just playing whit the settings offline (haven't used NisTune for a while!) so I wasn't planning on doing anything particular but I thought this was a bitt odd when I saw it! But I don't understand why I get 127 filtered when I enter 15 raw. (Warning, stupid question) Shouldn't it ...

Hi

Is there a bug in the Idle/Deceleration Timing vs RPM diagram?
The diagram sais for example 15 at 0 rpm when there should be 31 according to the information in that cell and if I change the cell to 15 or lower it "goes crazy".

I'm running 1.2.11

Hi Matt, I have another idea to spot differences faster when comparing. When the menu is folded I have no idea on where the differences is. Could you make so the group titles (I mean [+]Maps, [+]Scalers, [+]Limit tables and so on) change colour or get some kind of a marking (Like a * after the title...

Didn't think about that. But there is one problem with that solution. The guy how helped me to tune my car isn't familiar with NisTune and he only looked at the RAW value, my A/F and a few other thing so now in his map it says that my injectors are running on 136% duty on max load and 7000 rpm (with...

I would like that a warning message popped up (or something) when I go over for example 80% duty on the injectors.

That solved the problem. I didn't get the error message but the thing was that I have installed NisTune in C:\Program\NIStune but in Configuration is says C:\Program Files\NIStune\.... for translation and a few other tings (you can se it on the picture). http://200sx.kicks-ass.net/tim88/img4b95529f0...

When I start NisTune I get a message that says "undef" and on counsult display it says the same in every colum on the right side as you can see in the picture that I link to.

I run Vista Home Basic.

http://200sx.kicks-ass.net/tim88/img4b9399741e71c.jpg