Nistune Forums

ahhh ok. I figured out the check engine light. The wording was confusing me. I had the flag checked because it said egr temp sensor off.

I'm getting an over temp red light shows up in the bottom right corner in the nistune software? Also my car doesn't have the EGR system anymore but when I uncheck EGR system and leave egr temp sensor off checked I still get a check engine light for EGR related items.

Sorry been at work all week. I did resize but it was just once which is weird. I will try the changes later today and thanks.

This is the file I had loaded on the ecu. It would start for 10 seconds then shut off.

I also have a question about this. my bin file was used in march of last year and since then I didn't touch it because the car ran fine. Blew my head gasket it November and the car sat till I got around to fixing it 3 weeks ago. I installed nistune onto a new laptop downloaded the map and made a few...

confirmed it is set to 255 for the TP and speddo works. At idle you can hear it clicking the solenoids on and off. It's not long enough for the VVL to kick in so far just annoying.

Pin 105 is bridged directly to 102. This is since there is no circuit on pin 105 in the B13 ECU. So just run a wire between them The output should switch to ground (and activate the solenoid) when you see the VCT indicator in the 'consult view' panel active Also set the TP enable parameter to 255 T...

Damn I hope a AFC will works then. The price on them has been going down lately to 1200ish for engine trans harness and ecu. Thanks for the info Matt.

Anyone know of something that can be used to tune these ecu's? long shot but I'm running out of places to search.

I haven't opened nistune in about a year. updated to the new version and now when I check the volumetric efficiency map the tracer only moves vertical and only on the 1st load cell. The fuel and timing all trace normal still.

Anything new with this?

The safety rev limit was set at 8000 too. Will look into the speedo problem tomorrow.

The spedo isn't working but I'm not getting a code for speed sensor. I'm not sure if its a cluster problem been that its a nx1600 digital cluster.

got the errors again, grounds are good. Also noticed that the rev limiter isn't working. I have it set to 8000 and watched the tach race past 8000 rpm.

I just checked and the debug was off. I forgot I did a fresh install of nistune. I'll get out to the car again in a few days and I'm sure it will crash on me again. Do I email the logs to enquiries@nistune.com ?