Nistune Forums

Thank you. That would be very useful.
Do you have any sound clips where det is present?

soz, try that

Hi ya, I'm in need of some advice. I'm in the process of upping the boost levels to really start running some decent power and i've been using this kit to listen for det http://www.justoffbase.co.uk/Electronic-Stethoscope-Kit-Sealey-VS007 But I've not heard anything out of the ordinary so far so bef...

Hi ya,
My old laptop that I've been using to tune my car has given up the ghost and i've replaced it with an Acer One Netbook, but it runs Linux operating system.
Will I need to install windows xp to get the Nistune software running or is there any way I can run it through Linux?
Thanks a lot, Ben.

20+20 board soldered in and all working perfectly :D I followed the fitting instructions that came with the board step by step and it didn't actually say to solder the board in, and I did consider it originally but didn't use much inniative and stuck to the guide. Soz for wasting your time and your ...

Check if the ECU is in limp mode... 1. LED indicator on ECU stays on (also look at check engine light) 2. Car will run too rich and will not run above 2000rpm (limp mode) 3. Consult will not connect If the ECU with the external board jumper set to normal and no board plugged in does not work, then ...

Hi Matt, Tried with a small piece of wire but when I go to consult I get "consult not detected" The consult connects fine when CJ1 is bridged or neither of them are bridged but won't connect with CJ2 bridged. Also, when I bridge CJ2 my engine bay fans come on the instance I turn the igniti...

Hi Matt,

You're quite right, I'm not getting the second part on the ECU code when I connect.

But I have moved the ECU jumper from CJ1 to CJ2. Not very good soldering by myself though so i'll try and tidy that up first.

Hi all, Obviously a newbie and I'm struggling to get started. I've read through the Users Manual and the Tuning Basics which were very helpful but I now can't see where i'm going wrong. I've got a type 3 board and have a Pulsar Gtir, but when I change anything on the laptop it takes no affect on the...