Nistune Forums

Im confused , it does not seem to be the same as you are describing.
Feedback Switch 3: Bit 0 (01)
Feedback Switch 3: Bit 3 (08)
It`s not there.

I`m still having issues with this.
When i run Active Tests no fan runs on High Speed, but both fans run on Low Speed.
Is this normal?

I can also only get my fans to be on always or never.

I would like to know what to do to get my fans to work as i want. With these settings, the fans are on all the time as long as the enigne is running. Ideally i would like them to run when coolant hits 85c regardless of vehicle speed. I have tried the active tests, and i cannot get them to run indivi...

Thank you Matt!
This is what I was looking for.
How will I discover when the AFM's are maxed out in the future?

1000CC Bosch injectors, Stock MAF`s. While driving we max out the load scale really early so scaling/ setup is wrong i believe. So, maybe you could help me with a base map? So i will just need to adjust TIM and fuel/ignition. The Stock MAF`s cant be maxed out this early? 0.9 bar boost on gt2860`s. I...

Setup: R32GTR ECU in an R34GTR. Bosch 1000cc Injector (ballast removed). Upgraded turbo`s Stock MAF`s I need some help setting this software up, scaling loads ect before going on the dyno. The car has been at a tuning Company wich claims to know Nistune but the car is useless after they "tuned&...

This firmware does not support fans? I have to run them manually.
Have to change the firmware for a newer one?

I can connect to the stock ECU without problems.
It will not work with the R32 ECU.

ECU is a R32 ECU bought from Nistune and also modified by Nistune.
My consult cable and drivers are OK, tested and working in my S14.
Car starts and drives but Nistune will not connect.
Using correct adressfile (R32).

The CLK wire is checked and tripple checked.

Any ideas?

I`m about to install R32GTR ECU`s in an R33 and an R34.
Is it posible to not use the stock Lambda`s and feed a signal from the Innovate instead?
Does it have to supply signal to both inputs?
Any reason why i should not do it this way?

Thanks!

This solved my problem, thanks Matt!

I have tried again with no success.
There isnt any EDM FP maps so i tried ADM and JDM.

I need a step by step explanation so i can get this up and running.

After flashing I got adress file mismatch and when I load my map it won't start.

I tried that one with no success. Any tricks when it wants to change address files?
I need to be able to load my map in.

Trying to flash the featurepack to my type 4 Board.
I can`t find an exact match to my ECU so i tried the one marked in the Attached photo.
Does not work.
Wich one to use?

Thanks!