Zeitronix EGT shows different in Nistune

[s14unimog]

Not sure if this has been discussed but I couldn't find it anywhere. My Zeitronix's communicates without a problem, but my EGT display's differently than what is on my Zeitronix DRO. The temperatures shown in Nistune are significantly lower; could it be set to C* or something; I'll have to double check if that is what's showing. If that is the case, I would prefer to see imperial units... Am I missing some configuration window?

Has anyone seen this symptom?

Any thoughts Matt?


Thanks,
Brandon

[Matt]

Yes it shows degrees for that unit. Not sure about F*

Okay just looked at the Zeitronix protocol they supplied

Data block: data format
AFR HEX 8 bit
EGT LSB HEX 16 bit
EGT MSB HEX 16 bit

I assume the EGT is C* but it is not very clear. There was a config bit for the LCD to change between C and F but apparently we dont use that