Its possible to get no rev limiter or over 8000rpms

[Payu]

Its this possible I tried putting a bigger number than 8000 but still cuts at 8000

[TM_S13]

It's still not possible, yet, to go beyond 8000rpm with Nistune, if I'm not mistaken.

[HermaN]

TM_S13 is correct. Pretty sure Matt has it on his list of things to do, but it's not a top priority just now.

[CoZZm0]

I was under the impression from other reports (in a very recent thread) that setting it over 8000 resulted in NO rev limiter at all as the ECU never gets to count higher enough to engage the limiter.

[streetbike]

don't know what is working on type 3 but on type 1 CA18det it is working fine, mine is set to 8300 and it is working.

[TM_S13]

I think that on the last released version Matt was able to "correct" that feature for some boards... not sure wich ones though...

[CoZZm0]

I think that on the last released version Matt was able to "correct" that feature for some boards... not sure wich ones though...

According to a post by Matt himself, that isn't the case. Nistune never has supported it (which i thought it did for the type3) and he goes on to say in another post that you need TunerCode to support such a feature.

Nistune has never supported anything more than tuning the existing Nissan platform

Original recent thread where this was discussed is viewtopic.php?f=11&t=1507