Hi have a Type 1 in at the moment that was tuned a few years back in SA it has a 6 pin green connector (x3) on it and the usual x1 and X2 connectors.
It came in with no usb connected to x2 so i fitted one, but nistune wont recognise the ecu.. is there a jumper i need to solder on these older boards to enable USB or is it locked?
Got an old type 1 in here that had no usb, now wont connect
Moderator: Matt
Re: Got an old type 1 in here that had no usb, now wont connect
it should work still with the USB connector
Make sure pins are correct way around otherwise we can send you another connector for it
Make sure pins are correct way around otherwise we can send you another connector for it
Re: Got an old type 1 in here that had no usb, now wont connect
Got it sorted i had to back date my drivers to the original setup i had a 2odd years back then it talked fine... odd 