boards have arrived

Fusion Ed · Post by **Fusion Ed** » Tue May 15, 2007 12:49 am

Matt, My boards arrived today, thanks. I hope to have one in a car by the end of the week to see how they do.

Another question, now much more of ma09 rom has been learnt, would the type 1 board now be compatible with this ecu for consult and live remapping?

Cheers,

Ed

Matt · Post by **Matt** » Thu May 17, 2007 7:33 pm

I still have to run through all the consult addresses now for this... but yes it is compatible with the Type 1 boards based on the photos and ROM disassembly

Once I have consult addresses worked out can then program that into a firmware file and put into a board

Still a bit of work to do on this. I've been interstate this week so catching up on emails/forum postings will have to be next week

Fusion Ed · Post by **Fusion Ed** » Fri May 18, 2007 3:04 am

Cheers for the update. Thats fine

Matt · Post by **Matt** » Fri May 25, 2007 1:11 pm

Is this all working now?

Fusion Ed · Post by **Fusion Ed** » Fri May 25, 2007 9:56 pm

I tried a second board in another ecu. That worked fine. I ahve not tried the first board in the second ecu to see weather its the ecu or board, however I suspect its just the ECU.

Ed

Matt · Post by **Matt** » Mon May 28, 2007 1:30 pm

make sure the ECU has all 2x20 pins installed in it. missing pins like used on earlier PLMS boards will stop NIStune boards working

Fusion Ed · Post by **Fusion Ed** » Tue May 29, 2007 1:22 am

It has all the pins!! I would have spotted that a mile away