Using ID1000 injectors on R33 GTR

Nistune topics related specifically to the 6303 cpu

Moderator: Matt

Post Reply
PL
 

Posts: 957
Joined: Fri Feb 03, 2006 3:29 pm
Location: Adelaide, South Oz
Contact:

Using ID1000 injectors on R33 GTR

Post by PL »

Hey guys,

I've got a local guy tuning an R33 GTR using an R32 GTR ECU. He's done this before (you just gotta take care of the O2 sensor side of things) with good results.

He's fitted new ID1000 injectors which are high impedance. GTR's run low impedance injectors + dropping resistors from factory. So he's removed the dropping resistors now that high impedance injectors are fitted.

He's having driveability problems. Although he can tune it OK and obtain the desired AFR's it still runs rough and is apparently a pig to drive on the road.

Weird part is that he did one dyno pull where it cleared up and pulled like a train!

So we're both a bit stuck for ideas at this point. Apparently timing figures are all cool. Nothing untoward going on. I'm gonna get him to send me the bin and a log. Just thought I'd ask if any other GTR guys out there have run ID1000 injectors on these ECU's and if so did you have any issues?

Thanks
Pete L
bachig24u
 

Posts: 678
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: Using ID1000 injectors on R33 GTR

Post by bachig24u »

as long as the overall impedance matches the original, then the ECU wouldn't mind.

Is the battery voltage stable from idle right through the working rpm range?
PL
 

Posts: 957
Joined: Fri Feb 03, 2006 3:29 pm
Location: Adelaide, South Oz
Contact:

Re: Using ID1000 injectors on R33 GTR

Post by PL »

Yeah, that's what I said. All of the Nissan ECU's I've checked use the same injector driver chip. But some use low impedance injectors + dropping resistor and others just use high impedance injectors.

I'll ask him about the battery voltage. Or even better get him to send me that log which will show that anyway.

Thanks
PL
bachig24u
 

Posts: 678
Joined: Mon Jun 01, 2009 11:46 pm
Location: Campbelltown, NSW
Contact:

Re: Using ID1000 injectors on R33 GTR

Post by bachig24u »

yeah, those logs are absolute gold aren't they... if only they still worked!!! damn that 0.10.x upgrade .. arrrgh

I mentioned the battery because the volt latency delta is so important with large injectors.
the id1000's vary almost 250cc/1v from memory and if you have charge system problems or bad earths & don't notice it, the fuel map is used to compensate. Then the mess gets worse when the alternator or battery is replaced later on.
PL
 

Posts: 957
Joined: Fri Feb 03, 2006 3:29 pm
Location: Adelaide, South Oz
Contact:

Re: Using ID1000 injectors on R33 GTR

Post by PL »

Makes perfect sense. Might even give him a call now!

PL
STATUS
 

Posts: 119
Joined: Thu Jun 12, 2008 10:30 pm
Location: Melbourne
Contact:

Re: Using ID1000 injectors on R33 GTR

Post by STATUS »

Hey pete it should tune up fine, we have done a few now on e85 with id1000 's (which would theoretically make it 23% worse) even the id2000's seem to tune up fine.

haapy to have a look @ the map if you want to email it through but im sure your on top of that.
PL
 

Posts: 957
Joined: Fri Feb 03, 2006 3:29 pm
Location: Adelaide, South Oz
Contact:

Re: Using ID1000 injectors on R33 GTR

Post by PL »

Hey Trent,

Thanks for that. He did send me his map + log but I haven't had a good look at it yet.

I thought after all the good press that they should tune up pretty sweet.

PL
Post Reply