Nistune type 1 compatible with the engine CA18ET?

seb.racing · Post by **seb.racing** » Sun Jul 17, 2011 4:02 am

I put a pictures of an ECU

Nissan Silvia S12 CA18ET, made in April 1988

catalyzed version, oxygen sensor, EGR and charcoal filter

seb.racing · Post by **seb.racing** » Sun Jul 17, 2011 5:58 am

Nissan Bluebird turbo CA18ET U11T, made in June 1984

seb.racing · Post by **seb.racing** » Sun Jul 17, 2011 6:03 am

Matt wrote:Yes I need the chip removed from the ECU and read using an EPROM programmer so you can email me the BIN file

I just see that a French sellers is in your liter "Workshops / Regional Distributors"
I will contact, it may be you can transfer data from the chip

http://www.nistune.com/ordering-distributors.php

Matt · Post by **Matt** » Sun Jul 17, 2011 6:07 pm

Both ECUs are not supported. They however are the same hardware as Z31 1984-1985 ECUs

If they were to be done they would need to be sent here. Most likely we dont have address files and require special adaptors to read out the 24 pin chips

It would take upto a week to work on these so it would need to be when I am less busy

seb.racing · Post by **seb.racing** » Sun Jul 17, 2011 9:58 pm

Yes, I saw yesterday, despite the years, it's the same version in 24-pin
I can send you one of silvia S12
I understand, nothing is impossible despite 24broches
you can send me the shipping address? I will look for shipping

Matt · Post by **Matt** » Sun Jul 17, 2011 10:10 pm

standard mailing address:

Nistune Developments
PO Box 206
Surrey Downs SA 5126
AUSTRALIA

Nistune Forums

Nistune type 1 compatible with the engine CA18ET?

Re: Nistune type 1 compatible with the engine CA18ET?

Re: Nistune type 1 compatible with the engine CA18ET?

Re: Nistune type 1 compatible with the engine CA18ET?

Re: Nistune type 1 compatible with the engine CA18ET?

Re: Nistune type 1 compatible with the engine CA18ET?

Re: Nistune type 1 compatible with the engine CA18ET?