help innovate won't sinc with nistune!!!

[supersayianjim]

so i got my innovate lc1 to sync with my laptop(through logworks). but when i go to the options for nistune to read it it says "driver not selected". am i doing something wrong here??

[bachig24u]

did you tick the innovate option when installing Nistune?
can you see the innovate chosen ass wideband type and device serial port number in nistune configuration?

[supersayianjim]

i actually got the nistune to recognize the serial port that iam using for innovate. problem is i can't get the afr to read on the nistune screen, and when i open logworks and i have a reading from that apparently nistune can't access that port at the same time.

[supersayianjim]

well downloaded the new version of n.t. selected innovate in the add on selection screen and viola. works now. sometimes the cable to the wideband unit wont read, but i think thats more of a hardware issue on the 9pin to usb adapter.

[bachig24u]

i actually got the nistune to recognize the serial port that iam using for innovate. problem is i can't get the afr to read on the nistune screen, and when i open logworks and i have a reading from that apparently nistune can't access that port at the same time.

yep, thats right... only one program can access a serial device at any given time.

[bachig24u]

well downloaded the new version of n.t. selected innovate in the add on selection screen and viola. works now. sometimes the cable to the wideband unit wont read, but i think thats more of a hardware issue on the 9pin to usb adapter.

LC-1's can be painful at times. you often need to disconnect them, power cycle and reconnect to get them to come back to life.. especially if NIStune crashes.

try newest firmware from innovate support, its a little more stable.

[Matt]

Had similar issues with the LC-1 here having to unplug/replug everything