Hi all. I've been trying to find a wiring diagram or specific instructions on how to wire a Z32 AFM into a VL with no success. Can anyone help Me out?
Cheers, Locky.
Z32 AFM into VL?
Moderator: Matt
Re: Z32 AFM into VL?
it's in the Nistune software user Manual.
a search on Z32 finds a few relevant pages. p36 has the wiring info you need.
a search on Z32 finds a few relevant pages. p36 has the wiring info you need.
Last edited by bachig24u on Sat Dec 03, 2011 9:27 am, edited 3 times in total.
Re: Z32 AFM into VL?
Well I have a Z32 plug only, no wires. So I need pin numbers and what size resistor? I've read something about installing a Zener diode somewhere too?
Re: Z32 AFM into VL?
Type 1 hardware install manual for the mods (end of doc). I've removed zener diode part
Software Users Manual for the RB30 - Z32 AFM plug wiring required. I've found the resistor for calibration to be optional (ie tie to ground and then tune setup as this)
Software Users Manual for the RB30 - Z32 AFM plug wiring required. I've found the resistor for calibration to be optional (ie tie to ground and then tune setup as this)
Re: Z32 AFM into VL?
Can someone link me to a diagram?
Re: Z32 AFM into VL?
So I have found out which wires go to what pins on the Z32 plug and the mod to the ECU. Just need to know where to put the ~382 ohm resistor.
Re: Z32 AFM into VL?
Red/yellow wire and ground (black)