'Burn' to ECU in Stream-Mode no Error Display! (0.11)

[Torque]

When trying to 'burn' changes permanently in stream-mode there is no
error message that it didn't happen!

I think there was not even one of those tiny and easily overlooked messages in the
lower frame of the window.

This should really be made clear to the user!
(Alas a big fat requester / screen flash / beep etc)

[bachig24u]

stream mode is only for data logging in HD.

[Torque]

Hello ..

Yes, I know buuut
I find it often difficult to see/remembering in which mode I am especially when you're in the middle of tuning or in the 'field'
(Matt will hopefully come up with some kind of visual status bar (some kind of traffic light indicator))

If you want to burn changes (in stream-mode) to the ECU Nistune doesn't inform you that it did not actually burn anything.
This leaves you in the false assumption that the ECU has been burned.

There is a requester coming up whether I want to burn or not and if you click on OK (for burn) Nistune just doesn't inform you
about the 'non-burn'

The requester which comes up shouldn't come up in the first place.
This is a bug!

[bachig24u]

check the status bar at the left bottom corner.
it normally lists the last operation performed.