sorry to bring this up again, just had a chance to record a couple of runs.
now this one i saved as a "good run" and when i glanced at the boost gauge it was around 18psi.
i would have thought that the maf would have to be reading 7 volts, maxed out. it is just a vl maf in a 3" pipe.
MAF voltage in log playback issue
Moderator: Matt
Re: MAF voltage in log playback issue
- Attachments
-
- friday good run 01_2013-03-29_1028_54.csv
- (86.66 KiB) Downloaded 124 times
-
- nistune 03.JPG
- (281.96 KiB) Downloaded 1179 times
Re: MAF voltage in log playback issue
If its a VL MAF then it should add the offset voltage automatically. Right click on VQ map and see if offset has been ticked/unticked
If the VL MAF VQ map was modified at all then the offset is not used
If the VL MAF VQ map was modified at all then the offset is not used