Like the title says I can't rev past 8100. I have the rev limits set to 9000 and the Load limits up but it still cuts out right around 8100. Any ideas?
Z32 Maf
Built Motor
62mm T4 turbonetics turbo
1200cc injectors AEM fuel pump
CA18DET Type 1 board won't rev past 8100
Moderator: Matt
Re: CA18DET Type 1 board won't rev past 8100
Limitation of the Nissan ECU is that the max rev limiter is 8000rpm. Increasing the RPM limits beyond these without us modifying the ECU wont will make no difference
Re: CA18DET Type 1 board won't rev past 8100
is this valid only for ca18det ecu? As for example n15 ecu can rev over 8000rpm...
Re: CA18DET Type 1 board won't rev past 8100
Most ECUs are limited to 8000 due to coding used
Re: CA18DET Type 1 board won't rev past 8100
the same for sr20 ECUs ?Matt wrote:Most ECUs are limited to 8000 due to coding used
Re: CA18DET Type 1 board won't rev past 8100
Yes that is correct. However SRs don't particularly like being reved over this much anyway
Re: CA18DET Type 1 board won't rev past 8100
stock SR's - yes, but I was thinking to build one for 9krpm, and didnt knew about rev limiter...Matt wrote:Yes that is correct. However SRs don't particularly like being reved over this much anyway