Single ROM to dual ROM ECU swap
Moderator: Matt
Single ROM to dual ROM ECU swap
I have a CA18ET ECU, 23710-33F11, with a bad install so I've eventually sourced another ECU. This ECU has two ROMS, will I need a different Base image on the nistune board or will the ROM 33F01 work without modification? Thanks in anticipation
Re: Single ROM to dual ROM ECU swap
Will work without modification. 33F11 (AT) and 33F01 (MT) if you are using a manual transmission vehicle
I think this one only has a single 28 pin ROM. If there is a 24 pin chip, that may be a RAM chip (which should not be removed). The ECU should be the same as what you had previously
I think this one only has a single 28 pin ROM. If there is a 24 pin chip, that may be a RAM chip (which should not be removed). The ECU should be the same as what you had previously