R34 GTT load scale not tracing

[Chris250]

I'm having great fun with this GTT!!!

Changed the AFM for a Z33 so I could get a good resolution through out the rev range, trouble is since changing I've not had the load scale on the fuel mixture map trace across the X-axis of the map.

I've attached the log and bin file.

[Matt]

Its been a common issue which is seeming to come up today (with all models!) where the TP tickbox is becoming unticked in the latest versions

Display > Select Consult Registers

Tick the 'TP (load)' or the 'BFuel Schedule (TP)' tickbox to enable load tracing again!

I'll make a fix this week to force it back on!

[Chris250]

That's great, thanks Matt. I'll give that a shot in the morning

[Chris250]

Gave that a shot and it was already selected. When I unplugged the MAP sensor and switched off the faults it started tracing across the map as it should.

I'm getting another problem that I thought was the standard maf going hugely rich once it starts to boost, or when I'm full throttle. What's the usual suspects for this? To scaling?

R34 GTT
bigger turbo
cat-back exhaust
FMIC
Blitz SUS cone filter
DW 700cc injectors (hate these things)
Z33 AFM

[Matt]

Try pulling back your injection multiplier a bit so its not running so rich. Once you have that right, adjust your TP scales on your fuel and timing map

The log you posted showed no 'TP' register selected initially

[Chris250]

Back on this GTT again, Matt could you look at these logs and confirm there's nothing the ECU is doing that could cause the misfire, it's load dependant from the looks of things so I'm guessing that the ebay coils just aren't up to the task

[Chris250]

data log from dyno run

[Chris250]

bin file and short data log with low boost

[Matt]

fuel maps need a bit of cleaning up. You have it going too rich and then lean. Normally with an R34 it goes up smoothly and then flattens out, not a valley at the top end

You can see this in your dyno graph also, it goes richer at 3000rpm and then goes leaner. You want a nice smooth curve once you've reached your target boost AFRs

Regardless of this, the logs arent showing me anything showing problems with timing. I'm seeing about 21 degrees timing at the top end and 10ms injection time until you get the ignition cut around 4500rpm.

The cut appears unrelated to the tune itself, so would be looking at the plug gap and coil setup

[Chris250]

Thanks Matt, just needed that confirming. I know the tunes a mess, I've started with a blank standard tune and just addressed the areas this misfire to try ruling out the tune

[Chris250]

double post

[Chris250]

Eventually!!! a set of genuine Nissan coils off of a low mileage engine and we have a finished map, one little miss half way through the run but apart from that all good. I really should have just stuck to my guns at the start and got a set of decent coils in

https://www.youtube.com/watch?v=_q2VIcw36Oc

[Matt]

Yeah the coils in these are old... mine are giving up on me also. Looking for replacements soon