Attempted write failed?

[Torque]

VERSION 1.2.54
WINXP

Nistune won't change the K multiplier, have not tried anything else.
Logging, reading, uploading works.

Can we please have a big fat error message/requester/alert for critical errors?
(Or flash the screen red)
The tiny text in the left lower quadrant is not easy to spot.

2-16-2016 3-29-37 PM.jpg

(169.46 KiB) Downloaded 1629 times

[Matt]

The error is a bug, the status is a warning for recording to the log

It should not happen. The log shows
"Attempted write failed (ECU valid range) at 97E52609"

I did see this here once with that build but have not been able to repeat it since. The address is not valid and should be between 0000-FFFF (16 bit number). I tried to repeat with your board 41P03 Z32 with 1.2.56

Please try this version and let me know if you still see the issue

[Torque]

Thanks Matt,

Interesting that the address range is out range.

Is it possible to have a requester pop up for any kind of critical error?
I was really wondering when I altered K and the engine was just not reacting as it should.
(Because I initially did not spot that message)


Will check the newer build.

[Matt]

When it is an error (bug) it is unexpected, so there is not a pop up as such for this particular problem. Let me know how the newer version goes. I suspect is is a build error rather than code bug (since cannot be reproduced in later versions)