Type 1 ca18det dwell settin for bosch coils

[Datto1600ca1det]

Hi guys

This is my first post

Im runnin a type 1 board in my ca18det and i have just changed over to a bosch coil early vt 5.0l i think and i need to adjust the dwell to suit but i cant find what there dwell settin should be and my dwell settins currently look a bit out of whack

[Matt]

Yes they look out of wack. Only modify the dwell vs voltage table

There should be a 'dwell time' guage which you can look at to see the current ms (dwell charge time) estimated by the software. The dwell time from memory is about 3.5ms so if you double the default values in the dwell/volt table it will effectively make it about 7ms for example

[Datto1600ca1det]

Cheers for the reply is that the dwell time table i need to change

noob question

[Datto1600ca1det]

Here is a veiw of all consult guages while.runnin

[Matt]

replied via email. Also your other post on the Type 1 tune thread

[Datto1600ca1det]

Cheers Matt