Rb26 stands alone loom

[cruzy6]

Hi. Im doing an engine conversion with an rb26 from an r32 gtr.
How does nistune connect to the ecu.
Is there any particular plugs i need to keep on the factory loom?
Also. If i run a single slot afm. Will the factory plugs get cut off and spliced together?
Thanks

[Ross]

Yes, Nistune connects through the Consult port. This can be wired directly to the ecu; it's not necessary to use the port in the OEM location.

Also yes, you would connect both MAF signals together to one MAFS.

Regards,

Ross

[cruzy6]

Hi. Thanks.
Could some one post a photo of where on the loom this plug is and what it looks like.

[Matt]

Pinouts here:
http://nistune.com/docs/MAF_and_Consult_pinouts.pdf