Load limit
Moderator: Matt
Load limit
Hey so I been having problems with my rb25 s1 swapped in a s14. Sometimes when I get into boost its hesitates and seems like the ecu is cutting it off for some reason. I'm currently on the stock tune still, with basic bolt on and using a rb20 maf.
- Attachments
-
- stock map from ecu.bin
- (32 KiB) Downloaded 74 times
-
- NIStune_2019-03-14_1705_31.csv
- (132.41 KiB) Downloaded 57 times
Re: Load limit
You have transplanted the engine. There is no speed signal to the ECU (always 0). So it's using safety rev/load limits. Increase these to fix the problem
Re: Load limit
Would I just increase the Speed limit 1 in the limit section or the other limits also?Matt wrote:You have transplanted the engine. There is no speed signal to the ECU (always 0). So it's using safety rev/load limits. Increase these to fix the problem
Re: Load limit
Just the ones I have told you
Also Nistune 1.3 will tell you what limits. There is no point changing the speed limit, since you have no speed input
Also Nistune 1.3 will tell you what limits. There is no point changing the speed limit, since you have no speed input