WGC34 Stagea Tuning

[Matt]

Can you repost the issue? Dont see it above on this page.

Try 1.3.2 version and let me know if still a problem and what RPM you are trying to set the LC at

[Stick]

Having some issues with TPS still (cant reset TPS idle). Finally got around to reconnecting the factory boost sensor, which made the car idle funny, disconnected it and it would stop. Idles ok (if TPS idle active), but as soon as the TPS idle flag drop from just cracking the throttle, it hunts RPM about 70 rpm, and timing fluctuates between 0 and 30 (same as what it did with the boost sensor connected). If you open further, timing goes to 0 and stays there. Not sure whats going on.

Ive attached a idle log (voltage reg is hooked upto boost sensor input in this log) and current map.

Matt.. help!

There was a couple other posts below this one as well with info

[Stick]

Was trying to set it to 4500rpm. Worked in the past.

[Stick]

Matt,

Still having issues trying to set launch control parameters. Ive attached logs of when LC Rev Limit Retard is set to my desired rpm of 4800 and causes problems, and then another log if it is set to 12800 and works fine. As you can see in the 4800 log, when the throttle is pressed slightly, the timing starts fluctuating like crazy, even though throttle position does not change, then when it is set to 12800 timing does not fluctuate

Any ideas what is causing this?

[Matt]

That is strange. I'll try it out on the bench. is it only 128000 which effectively disaables it? So any other RPM is an issue?

It is like it is retarding and then stopping/starting continuously?

[Stick]

Anything other than 12800 and it causes the problem.

Yeah, its really odd, its driveable when it does this but timing still flops about all over the place. I've just set it back to 12800 for the time being

[Matt]

It doesn't do this if the LC is unticked?