Consult cable from aliexpress

[kamilp1908]

Hi.
I have this consult cable: https://www.aliexpress.com/item/4000241208883.html
Does anybody use similar cable?

Before installing Nistune Type 3 board I could connect ECU using Nistune software.
But after installation Nistune board I can't connect to ECU with Nistune software.

Is there problem with cable or maybe Nistune board uses different/extended protocol version?

[Matt]

Sounds like board install problem if you cannot connect. All cables should be the same as far as protocol, just the PLMS ones have better noise filtering

[kamilp1908]

I think that board should be ok, because I can start car.
And I am sure that board is working ok, due to the uploaded maps in Nistune are from different car and engine works different from stock ecu.
Maybe I made a mistake when I have soldered the 2x20 gold pin connection port. Which line is responsible for communication with consult in this port?

[Matt]

Check 'communications and diagnostic' guide on website. Just because car starts, it might be in limp mode. Check list in document for each ECU.

[kamilp1908]

Ok. I will do according to manual.
First thing I will resolder std ECU jumper and validate this cable.

[kamilp1908]

I have checked the LED on board with Nistune board inside. It is ON, so You are right (it is in limp mode). I have to check all 2x20 gold pin connections. It is only place where I could have made a bad soldering.