Zeitronix ZT-2 lamda question

Ashley · Post by **Ashley** » Sat Jun 14, 2008 3:45 am

Good Evening guys...

Will I be able to feed my Zeitronix ZT-2 lamda out-put into my non-lamda (non-cat) ECU?

I have looked through the service manual and its Pin 29 on the ECU , Just asking if anyone has done this

Matt · Post by **Matt** » Wed Jun 18, 2008 3:14 pm

depends if the CA18 ECU hardware for that model supports reading it in and also if the ECU ROM which is programmed into the board supports it

you can check the O2 sensor feedback and see if it responds if you plug the O2 narrowband output into the ecu