I just got my e5 sr20det ecu from glen at aaa hiperformance. It has the type 3 board installed in it. I hooked it up to my car and made the changes to my maf and injectors with the key on, the consult cable connected and the consult button hit on the program and the engine off. I went to burn the image to the board and it asked if I was sure I wanted to and I said yes and then it said that this feature is only avabiable with nistune realtime boards. I checked to make sure that there was really one in there and there is. Could a jumper be hooked up wrong? Is my software out of date possibly? V.9255
my cable is a plms cable. As far as I can tell i have done everything right. Any help would be nice.
will not burn bin to board
Moderator: Matt
I just got this issue resolved earlier today. Glen forgot to move the jumper to read from external memory. I moved it over with my crappy solder gun (low watage and heat though) and it works like a charm.
I tuned on it for about 45 minutes (actually about 10 mins total tuning, the rest was driving) and Im confident that I already have a better tune than my old JWT ecu and I can already see the areas I can improve, I just ran out of time tonight.
My only issue with it was that my innovate wideband kept going offline but I think i read this issue is being addressed. I would think it would work good enough on a dyno for a pull but when it goes out of bounds it stops working.
I could get you logs for that if it would help you or anything.
Anytime I can do anything for you to make this program smoother let me know, im more than willing and Thank you for this great product.
I tuned on it for about 45 minutes (actually about 10 mins total tuning, the rest was driving) and Im confident that I already have a better tune than my old JWT ecu and I can already see the areas I can improve, I just ran out of time tonight.
My only issue with it was that my innovate wideband kept going offline but I think i read this issue is being addressed. I would think it would work good enough on a dyno for a pull but when it goes out of bounds it stops working.
I could get you logs for that if it would help you or anything.
Anytime I can do anything for you to make this program smoother let me know, im more than willing and Thank you for this great product.