Consult gauges

Twin-turboZ · Post by **Twin-turboZ** » Tue May 30, 2006 11:42 am

Would be great to have a re-setable peak readout for the consult gauges so that at a glance you could see what the peak values for a particular run was without having to look at the data log.
Maybe just some digits beside or at the bottom of the bar graphs and maybe digits at the bottom of the gauges.
Perhaps in red to differentiate from the readouts.

airdamien · Post by **airdamien** » Thu Jun 01, 2006 10:15 am

Why do we need to be able to see peaks?
I would much prefer the time being spent showing an overall run, unless you only run your engine in one state.

Twin-turboZ · Post by **Twin-turboZ** » Thu Jun 08, 2006 11:51 am

I just find the peak indication handy for a preliminary run to make sure that i am not maxing things out. like AFM, inj duty cycle and also the max TP tells what the map scaling needs to be in order to make the top end tuneable.
If its a car that you are not familliar with then one quick run can give some preliminary info.
I realize that this can also be found in the log but its quick and easy if there are peak values shown.

Not a biggie just another nice to have..

brett_32i · Post by **brett_32i** » Mon Jul 07, 2008 2:26 pm

i agree with it being a great idea. a common idea i've seen in practice is the peak needle is reset every 3 seconds. works well, better than a user reset.

Matt · Post by **Matt** » Tue Jul 08, 2008 1:27 am

added to the enhancement list!