timing map and load scales question

Noodleman · Post by **Noodleman** » Sat May 02, 2009 6:15 am

Alright i currently am running a type 4 board on a ka24de s14, when comparing maps between two .bins, can i possibly interchange the timing maps even thought the load scale is different? For example, i have a .bin from another person that has almost the same setup as i do and wanted to use the timing map he is using but his load scale is slightly different. I just want a safe timing map so i can at least get the car on the road.

Matt · Post by **Matt** » Sat May 02, 2009 2:11 pm

you can select the map and then copy it. i would suggest copying the scales also otherwise you are going to have timing on that map operating in different load/rpm areas which may cause troubles

Noodleman · Post by **Noodleman** » Sat May 02, 2009 8:00 pm

okay i will give that a try and see if that works out. thanks matt!

Noodleman · Post by **Noodleman** » Wed May 06, 2009 4:16 am

So if i copy the ign load scale would i have to copy the fuel load scale as well?

Matt · Post by **Matt** » Wed May 06, 2009 10:24 am

only if copying the fuel map... but usually it is best to have matching fuel/ignition scales so everything lines up

otherwise it can get confusing