Wiring in consult plug

aleks · Post by **aleks** » Sat May 02, 2009 1:16 pm

Just a quick question

I have a CA18 180 with a neo engine. I am going to wire in a consult plug and just wanted to check if I will need the CLK to be wired in (I'm assuming thi is the clocking reference?) because I can't find it in the wirring diagram

So will I need to wire in CLK?

Any help is appreciated.

Cheers, Alex.

Matt · Post by **Matt** » Sat May 02, 2009 2:12 pm

yes you need to wire in CLK, TX, RX, 12+, GND

details in here
http://www.nistune.com/docs/Installatio ... ostics.pdf

aleks · Post by **aleks** » Sat May 02, 2009 2:37 pm

Anyone know what pin number is CLK for a R34 NEO?

aleks · Post by **aleks** » Sat May 02, 2009 3:19 pm

I had to solder from the board thanks to some awesome wiring job

You wouldn't happen to know what pin number CLK is Matt? Neo connector isn't in the installation guide.

Cheers, Alex.

Matt · Post by **Matt** » Sat May 02, 2009 11:41 pm

silly me... ER34/WC34 RB25 doesnt have the clk line... just remembered. sorry about that

aleks · Post by **aleks** » Sat May 02, 2009 11:42 pm

Sweet, thanks.

datsunboy · Post by **datsunboy** » Sun May 03, 2009 1:19 pm

Is there any point to wiring a consult port into a CA18?
I thought they didnt have consult?
or is this for a Nistune CA ecu?....then whats the benfit of a consult port?

aleks · Post by **aleks** » Wed May 06, 2009 3:34 pm

I have a CA model 180... it never had a consult plug.

It now has RB25 neo (type 4 board) so I had to wire in a consult plug for it as only the type 1 boards have the usb consult add on.

Matt · Post by **Matt** » Thu May 07, 2009 12:52 am

engine conversion

datsunboy · Post by **datsunboy** » Thu May 07, 2009 12:06 pm

so obviously you got rid of the CA18 loom when you changed to an RB25....so if you used the RB25 loom, wouldnt that have a consult plug???

aleks · Post by **aleks** » Sat May 09, 2009 5:49 pm

aleks wrote:I had to solder from the board thanks to some awesome wiring job

Not my work