Where can i tune the injector latency?

Nistune topics specific to the 6802 cpu

Moderator: Matt

Post Reply
Dino
 

Posts: 22
Joined: Sun Mar 26, 2006 8:35 pm
Location: Germany, Nuremberg (south)

Where can i tune the injector latency?

Post by Dino »

you know what i mean, bigger injectors need longer to open and close. There is a value in the bins to adjust this latency. According to Jason the adress is HEX:7F88. Where can i change this @Nistune?
Bernardd
 

Posts: 253
Joined: Thu Jan 26, 2006 3:20 am

Post by Bernardd »

In the constants section "PREIGNITION TIME" just below the k value and above the feedback control.
Dino
 

Posts: 22
Joined: Sun Mar 26, 2006 8:35 pm
Location: Germany, Nuremberg (south)

Post by Dino »

ok, but

do i have to raise the value or decrease with bigger inj. (Benz 420ccm). How is the logic of that value. Higher value = higher latency or the other way round?
I think you use also the Benz injectors. What value would you recommend?
Bernardd
 

Posts: 253
Joined: Thu Jan 26, 2006 3:20 am

Post by Bernardd »

higher value=longer opening time

those injectors have a latency of 4D from what I've seen.
Post Reply