Inhibitor Switch

DuoWing · Post by **DuoWing** » Fri Nov 20, 2009 10:10 am

Hey I had a question and I figured this would be the place to ask since you guys have had so much experience working with the Type 1 ECUs, but over the course of wiring up my L28ET into my 76' 280Z I came across the inhibitor switch issue. I see that the inhibitor switch for the clutch or the P/N switch for automatics connects to the ECU. I don't know if this in some way can cause starting issues with the car? I was just curious if you happened to know how the inhibitor switch I believe pin 10 on the Z31 ECU interacts with it.

Thanks for any info.

Matt · Post by **Matt** » Mon Nov 23, 2009 10:11 pm

pin 10 is the neutral switch input. it will not have too much affect apart from perhaps idling coeffiecients

that runs to inhibitor relay also which stops the starter from cranking on automatic transmission models

davehoos · Post by **davehoos** » Fri Dec 04, 2009 7:14 pm

doesnt seam to make much difference when speed sencor is above 10-20Kmhr

had the car tunned to give me a good easy 11Km/L.
reset back to stock for more playing.
tps contacts change tune setting heaps.