Innovate LogWorks 3 SDK Now available! (LM2)

[Amien]

Got the system working perfectly Will loads some screen shots late.

[Matt]

No it is showed as LM2 USB but when I hit connect it said can't connect. I try with and without installed Logworks3 with same result.

I identified an issue here - when you connect to consult/disconnect it affects the port ordering

Its a pain, because the list of COM ports seen to innovate changes depending if you connect/disconnect or plug in another COM port after setting up the parameters inside File-Configuration-Wideband port

So what you previously configure can change depending on these factors

Logworks gets around this by popping up a port select box each time you connect to the unit. So you have to explictly specify the port each time

I've made it now skip through the list of COM ports to use the USB port in 0.9.14.2 so let me know how that goes, should work better now