Page 2 of 2
Re: RB25DET engine with Z32 ECU need help !
Posted: Mon May 02, 2011 2:49 pm
by Matt
No that is a software issue (I've fixed it for next release) to do with trying to detect the coefficient = 0 and then hiding the high gear maps. It appears different sequences of loading the files does not work so I've pulled out the changes for now
Re: RB25DET engine with Z32 ECU need help !
Posted: Mon May 16, 2011 6:31 pm
by guricha
Matt, Is there any chance to use Board from BNR32 on Z32 ecu to tune RB25? i want to order the board but this in case of limited time, i could remove board from my cars ECU and use in Z32, what you think ha?
Re: RB25DET engine with Z32 ECU need help !
Posted: Mon May 16, 2011 10:19 pm
by Matt
Board requires reprogramming with a base image programmer
Re: RB25DET engine with Z32 ECU need help !
Posted: Sun May 29, 2011 9:30 am
by Torque
Just a question without really getting all the issues here ..
Did the car run fine before you installed the Z32 ECU?
Have you tried swapping back the ECU?
Was the ECU tuned by someone, or are you using just the standard map?
Who prepared your Z32 ECU? (I mean all the soldering ...)
Re: RB25DET engine with Z32 ECU need help !
Posted: Sun May 29, 2011 9:31 am
by Torque
Matt wrote:appears different sequences of loading the files does not work so I've pulled out the changes for now
Good! I was never bothered by the maps showing up
Re: RB25DET engine with Z32 ECU need help !
Posted: Sun May 29, 2011 2:06 pm
by Matt
those are back in latest version
Re: RB25DET engine with Z32 ECU need help !
Posted: Sun May 29, 2011 7:06 pm
by Torque
Matt wrote:those are back in latest version
Have not upgraded yet, but am looking forward to it
Why not add 'expert mode' as a Menu item to make them show or not?