Page 4 of 4
Re: Flat shift
Posted: Sat Jun 25, 2022 12:33 pm
by Matt
No - there are no tickboxes to enable it
You should always see 'Pwr Steer' highlight when the input line is grounded
More details in the FP hardware manual:
http://nistune.com/docs/Nistune%20Featu ... nstall.pdf
Page 25 covers the pins used
Re: Flat shift
Posted: Sun Sep 25, 2022 3:09 am
by skylinegtrhr
Hi will there be maybe option to use LC and Flat shift in the same time?
Re: Flat shift
Posted: Mon Sep 26, 2022 3:22 pm
by Matt
No that is not possible, due to using the switch for the same input and the conditions. So either one or the other!
Re: Flat shift
Posted: Sun Jun 16, 2024 10:32 pm
by Juissi--
I have such a problem that when I set flat shift rev limit to say 4000rpm and flat shift min tps to say 1 volt, and I put the data in the ecu they change by themselves. Flat shift min tps goes to 0 and flat shift rev limit goes to 68rpm. I have installed a push button under the clutch pedal and at least the launch control works normally from it. Ecu is ca18det manual model fp1. Can somebody help?