Posted: Mon Mar 02, 2009 8:55 pm
dasmx is the disassembler. sorry only have fuel based cuts on these ECUs from whats been identified so far
Nistune Forums
Nistune is a real-time tuning suite designed especially for Nissan vehicles
https://nistune.com/forum/
Knock warning
Page 5 of 7
Posted: Tue Mar 03, 2009 12:00 am
Is dasmx useful for disassembling the code for the S14a-ECU (82F08)? I am not sure at the moment which CPU is built into the ECU.
Posted: Tue Mar 03, 2009 12:39 am
Shouldnt be too hard to modify it to an ignition cut
Posted: Tue Mar 03, 2009 1:03 am
there is a japanese based MELPS 7790 (6502 based 8/16 bit processor) called dasm77 and calum has worked on another one which is available from his website in a directory somewhere
The hard part is that there are flags which switch between 8/16 bit. I spent several months writing my own which traversed all paths of the code to produce the disassembly, and then I run my consult patcher through the disassembly
The hard part is that there are flags which switch between 8/16 bit. I spent several months writing my own which traversed all paths of the code to produce the disassembly, and then I run my consult patcher through the disassembly
Posted: Tue Mar 03, 2009 8:53 am
okay, I see that this is nothing for "I am looking in 15 minutes at the disassembled code". 
Thank you for your answer.
Thank you for your answer.
Posted: Tue Mar 03, 2009 10:39 am
shoot me an email if you want a disassembly done and I can do that for you
Posted: Tue Mar 03, 2009 11:17 am
Mail is on the way.
Posted: Fri Mar 13, 2009 5:34 am
Hey matt, i bought my nistune board a couple weeks ago. so has the knock detection feature been successfully set up or working properly on the Z32 boards?
Posted: Fri Mar 13, 2009 1:04 pm
not yet. thats one i havent been able to get working
Posted: Thu Mar 19, 2009 3:00 pm
any updates? lol sorry for bugging you im just really exited to see it work.
Posted: Thu Mar 19, 2009 10:06 pm
not yet. i've been working on the mapping guide and updating software/address files in the interim
Posted: Wed Mar 25, 2009 8:46 am
tic toc tic toc lol =(
Posted: Wed Mar 25, 2009 9:21 am
i've posted up the Rev15 ENT files here for people with programmers to try out. has anyone had any luck with testing these?
I'm unable to do board exchanges at the moment because we are out of stock with Type1/2 boards
Also currently doing some major updates to the software in regards to address file updates and tracing document so this is on hold whilst I wait for testing feedback
Still trying to get the Z32 knock count working however
I'm unable to do board exchanges at the moment because we are out of stock with Type1/2 boards
Also currently doing some major updates to the software in regards to address file updates and tracing document so this is on hold whilst I wait for testing feedback
Still trying to get the Z32 knock count working however
Posted: Thu Mar 26, 2009 4:34 am
will the z32 knock counter (when completed) require a firmware reflash for the type 2 board? (I purchased mine just recently, about 2 months back)
Posted: Thu Mar 26, 2009 10:41 am
yes it will. a few of the common ECUs have rev15 shipped out with them (you will know when you connect) and I'm going to regenerate all the ENT files soon with what i have done so far with this firmware