Page 1 of 1
r34 o2 Flags
Posted: Wed May 06, 2009 1:08 pm
by Pedro
Am I the only one that cant turn of the 02 sensor flags on the R34
or is it just not possible
Posted: Thu May 07, 2009 12:48 am
by Matt
O2 feedback sensor flags are not possible on the R34. I've removed the feedback switch options on this ECU in the latest debug version
You will need to change the O2 feedback temp instead
Posted: Thu May 07, 2009 11:15 am
by Pedro
where abouts is the o2 temp feedback located ??
Posted: Mon May 11, 2009 10:14 pm
by aleks
I was thinking this aswell.....
Its not in the adress file
#Feedback control
O2_FEEDBACK_TEMP
Posted: Tue May 12, 2009 1:03 am
by Matt
O2_FEEDBACK_TEMP,&H2033,1,1,1,1,Feedback control
its in the latest beta version on the site, bundled with the software release
Posted: Tue May 12, 2009 10:29 am
by Pedro
Will this effect tuning if I dont do anything with that settings ??
Posted: Tue May 12, 2009 7:53 pm
by Matt
it will use the O2 sensor feedback and affect your wideband readings at times where its trying to use closed loop
Posted: Tue May 12, 2009 9:08 pm
by Pedro
can i just unplug the 02 sensor and tune it
will i need to change the temp settings for tuning then change back when tuning is completed or does the settings stay adjusted for good ?
also what do the settings need to be out to ?
Posted: Sun May 17, 2009 2:38 am
by Matt
you can unplug the O2 sensor
you can increase the temp to maximum (205 degC which wont be reached). reset this when finished. what ever you change and then burn stays there until changed otherwise