have i done wrong?
Posted: Tue Jul 28, 2009 1:44 pm
sr20det redtop
550 cc inj
n60 maf
s13 wiring harness
s14 chassis
50f00 ecu with type 3 board
have programmed and re-programmed board using base image programmer and sr20det redtop 50f00 base image, but to no avail. cannot connect via consult. first, found out wires weren't even connected. connected wires from ecu to consult and still no connection based on pinout diag found here in the forums.
discovered how to make ent file with upgraded inj and maf and re-programmed via base image programmer. car still won't start.
what is the normal steps to setup? here's what i'm doing:
1. programmed type 3 board via base image programmer
2. re-soldered j1 and de-soldered pgm
3. car off connect to consult and open nistune
4. key on engine off and try to sync w/ ecu and=not connected
5. led is on when key on engine off, but goes off while trying to crank car
6. last night car would start, but would die out after a few seconds because it was on stock bin (not upgraded for larger injectors or maf)
help me here before i stick a rag in the gas tank and light it up.
550 cc inj
n60 maf
s13 wiring harness
s14 chassis
50f00 ecu with type 3 board
have programmed and re-programmed board using base image programmer and sr20det redtop 50f00 base image, but to no avail. cannot connect via consult. first, found out wires weren't even connected. connected wires from ecu to consult and still no connection based on pinout diag found here in the forums.
discovered how to make ent file with upgraded inj and maf and re-programmed via base image programmer. car still won't start.
what is the normal steps to setup? here's what i'm doing:
1. programmed type 3 board via base image programmer
2. re-soldered j1 and de-soldered pgm
3. car off connect to consult and open nistune
4. key on engine off and try to sync w/ ecu and=not connected
5. led is on when key on engine off, but goes off while trying to crank car
6. last night car would start, but would die out after a few seconds because it was on stock bin (not upgraded for larger injectors or maf)
help me here before i stick a rag in the gas tank and light it up.