Page 1 of 1

narrow band output on lc1

Posted: Thu Jul 30, 2009 1:45 pm
by highoctane
I've got an lc1 and there is two outputs. Analog two is being use to connect to my Db blue gauge for monitoring. There is also an analog output one that is a simulated narrowband (1.1V = 14AFR AND .1V = 15AFR). This output can be use as a signal to the ecu, but I cannot find out what type of narrowband my vehicle use. Scrolling through the FSM doesn't tell me anything. Either that or I'm just looking in the wrong section.

Can this just be connected to feed signal to the ecu without adjustment? This is on a s14 ka24de btw.

Posted: Mon Aug 03, 2009 4:57 am
by koukimonster
Yes, you can just connect analog output 1 of Lc1 to the signal in of ECU.

But program it in lc1 logworks software, change the analog 1 response time to 1/6 of a second !.

Posted: Mon Aug 03, 2009 2:27 pm
by highoctane
koukimonster wrote:Yes, you can just connect analog output 1 of Lc1 to the signal in of ECU.

But program it in lc1 logworks software, change the analog 1 response time to 1/6 of a second !.
Awesome, I'll do that once I get my knock light working properly so that I can run/test the car again.