Page 1 of 1
Newbie question.
Posted: Thu Dec 31, 2009 9:17 am
by robertsr20
Hi happy holidays to everybody.
I have a Type 3 board with base image for SR20DE+T but I've sell my car without board and my new project is another B13 with VVL swaped the question is, can i use my board for these engine?
Can get the signals to activate the vvl selenoid?
Thanks.
Posted: Thu Dec 31, 2009 1:32 pm
by Matt
you will need to get the board reprogrammed for that B13 ECU (base image programmer required)
you will need a buddy club or similar external VCT solenoid controller since type 3 boards dont have external controller capability
Posted: Thu Dec 31, 2009 11:57 pm
by skylinegtrhr
Matt wrote:
you will need a buddy club or similar external VCT solenoid controller since type 3 boards dont have external controller capability
buddy club V-CON ?
Posted: Tue Jan 05, 2010 6:35 am
by robertsr20
Matt wrote:you will need to get the board reprogrammed for that B13 ECU (base image programmer required)
you will need a buddy club or similar external VCT solenoid controller since type 3 boards dont have external controller capability
Thanks Matt, I solved my problem with a basic board with vvl image and install an external module to control the selenoid, now my car is running
BTW are ready the new base image programmer?? I need one let me know please.
Regards.
Posted: Thu Jan 07, 2010 5:51 pm
by Matt
got the newer USB base image programmer almost working. it programs Type 3/4 boards but some problem with final byte on Type 1/2 boards which I'm working on
Also we have to update the USB programmer prototype board (again) for Type 5 board due to the complexity of programming that thing
Works well reading OBD-II ROMs out of aftermarket boards which is good