Page 1 of 1
buddy club V con
Posted: Thu Feb 25, 2010 8:02 am
by sky_r33
I'm using an r32 ecu on my R33 Gtst RB25DET, I'm trying to install the buddy club V Con and don't really know where to connect the wires ( I know the power 12V and the ground) but what about the rest?
Re: buddy club V con
Posted: Fri Jun 18, 2010 7:59 pm
by sky_r33
I have the ecu pin outs but I get stuck there because I don't know where exactly connect the rest of the wires...
some help please
Re: buddy club V con
Posted: Sat Jun 19, 2010 11:22 am
by Matt
I cant really help with this one since I never have used one. However what are the wires which the buddy club requires.
What cant you find matching on the ECU pin for this unit?
Re: buddy club V con
Posted: Tue Jun 22, 2010 9:00 am
by sky_r33
I got this info from the Honda guys..
1)splice orange/white vtec signal wire
2)attach grey wire from buddy club- vtec input (orange/white wire)
3)attach yellow wire - vtec output (orange/white) the other end of the vtec signal wire
4)attach black wire - black wire (ground)
5)attach green wire -rpm signal (red/green)
6)attach red wire - yellow/black (ignition power)
Re: buddy club V con
Posted: Tue Jun 22, 2010 9:50 am
by Matt
I would assume orange/white and - output would go to your VTC solenoid
Ground and ignition power are easy (end power wires on your Nissan ECU) and RPM signal would be the CAS 1 degreee input on your Nissan ECU (normally green striped wire)