Nistune Forums

version 0.9.14.2 and sadly no debug log

loaded nistune in stream mode (happens in tuner mode aswell)
connected consult
loaded WB 02 LH (lc1 wideband)
then opened current map saved
opened log player
clicked on browse so i could change log name and clicked open,
then i have a problem

Consult and WB 02 LH disconnects and log player not showing new log name.
Happens everytime even with a laptop restart.

when you open the browse window it 'assumes' that you are loading a file

when this occurs it disconnects consult/wideband on purpose since there can only be one source of data (either live or from the log file)

perhaps I can delay this until a file which exists has been open before disconnecting which could avoid this problem

Trying this out now. If you click 'name' that will change the name of the file without needing to browse

Anyway I have put in additional logic to check if the file name does not exist. If it doesnt then it will stop recording (if currently doing a record) and then change name and get ready for the next recording