Page 1 of 4
Need someones tune.
Posted: Wed May 12, 2010 10:33 am
by GavinJohnson
While tuning my car it's not behaving at all. Does anyone have a tune for an rb20, 555cc injectors, z32 maf, forward facing intake, 3" turbo back exhaust, t3t04e turbo or similar they could send me to try and see of it's my tuning or something wrong with the car please? If
not I'll post up what problems I'm having but just want to rule this out first.
Re: Need someones tune.
Posted: Wed May 12, 2010 6:32 pm
by beng2k
What type of problems are you having? the stock maps will allow you to start and run the car if you change the injectors and MAF and then adjust the latency and multiplier
Heres my post from the post before your's about an Rb25, same shit...
from there its as easy as using the resize injector function first then the change maf function next...that will roughly account for the tp scale adjustment (which is pretty close from my experience, which is less than a month)
from there you need a wideband and setup the injector multiplier and latency based on your injectors....set it to auto and adjust the sliders. Playing with latency first. As one changes, the other needs to change as well to accomodate. This should get it idling around 14.7. Dont forget to disable O2 feedback by reading the manual.
from there its either street time (like me) or dyno time (which comes soon)
i cannot stress the importance of reading the documentation like 10 times at least while looking at the software
Re: Need someones tune.
Posted: Thu May 13, 2010 12:43 pm
by GavinJohnson
Ok so found out it was a boost leak. Now everythings back together and my timing is at 60 doesn't move at all whether on decel, load, no load, idle anything. As soon as I start it it's at 60. No trouble codes and I tried replacing knock sensors just incase. Any ideas??
Re: Need someones tune.
Posted: Thu May 13, 2010 9:17 pm
by TM_S13
have you adjusted the base timing via the CAS ? not sure if it will need consult software too or not though...
Re: Need someones tune.
Posted: Fri May 14, 2010 2:01 am
by GavinJohnson
Yes I have. Doesn't Change. Unplugged my knock sensors and it went to 35 and came up with knock sensor code. Since I've swapped the sensors I'm guessing the wiring to them is bad
Re: Need someones tune.
Posted: Fri May 14, 2010 2:13 am
by GavinJohnson
*35 cause my idle was at around 11-1200*
Re: Need someones tune.
Posted: Sat May 15, 2010 3:22 am
by GavinJohnson
Replaced the wiring to the knock sensors so I'll try that tonight.
Re: Need someones tune.
Posted: Sun May 16, 2010 6:38 am
by GavinJohnson
Ok so timing is good and then I turn the car off and turn it back on and it's at 60 and doesn't move. Anyone have any ideas??
Re: Need someones tune.
Posted: Sun May 16, 2010 9:38 am
by Matt
What part number 23710-xxxxx is on your board?
Is this the first time timing has been stuck on 60? Does it also report this in 'stream mode'?
Re: Need someones tune.
Posted: Sun May 16, 2010 12:59 pm
by GavinJohnson
Where do I find that matt? Yes it is. It's been in the cAr for about 2
months now while being tuned. Just started doing it. No just consult mode. When I look in the maps it's moving around like it should..
Re: Need someones tune.
Posted: Sun May 16, 2010 3:31 pm
by Matt
At the top of the screen in Nistune when you connect will show an ECU ID. You will see it when you connect to the ECU
Re: Need someones tune.
Posted: Mon May 17, 2010 3:18 am
by GavinJohnson
23710-11u00 rev:15 (u)
Re: Need someones tune.
Posted: Mon May 17, 2010 9:34 pm
by Matt
thats a very used ROM image so not that
do you have 'timing' selected in the consult gauge list when first connecting?
otherwise will need a debug log
Re: Need someones tune.
Posted: Tue May 18, 2010 6:39 am
by GavinJohnson
Yes i do. It stays at 60 how do I do a debug log?
Re: Need someones tune.
Posted: Tue May 18, 2010 10:23 am
by Matt
File - Configuration - Debug logging
restart Nistune
Logs get put in C:\Program Files\Nistune\logs
Do a short test in 'stream mode' and email that through
Test with both idle and then mid throttle. I need to see if it changes at all. Strange its not going with that particular ROM image