Page 1 of 1

RPM LOAD SCALE QUESTIONS

Posted: Sat May 15, 2010 11:16 am
by silva2786
Hey everyone im having a little of a headache can i add more than 15.00 scales see in total u have 16 bars of load for rpms, fuel, etc... well i want to know if i can go up to 20.00 reason being so i can have more control of my timing/fuel management thanks

Re: RPM LOAD SCALE QUESTIONS

Posted: Sat May 15, 2010 2:33 pm
by Matt
With the Nissan ECU you are stuck with 16 load columns and 16 RPM rows

If you are running out of resolution in a particular area, it is best take it from another area

For example on boost you may want to have more finer control over the maps there, so spread out the scale numbers on the lower non boost end and then make them closer together at the top end.

It will give you that finer control where you need it. Hope that makes sense