Page 1 of 1
Where can i tune the injector latency?
Posted: Tue Jul 11, 2006 6:20 am
by Dino
you know what i mean, bigger injectors need longer to open and close. There is a value in the bins to adjust this latency. According to Jason the adress is HEX:7F88. Where can i change this @Nistune?
Posted: Tue Jul 11, 2006 7:19 am
by Bernardd
In the constants section "PREIGNITION TIME" just below the k value and above the feedback control.
Posted: Tue Jul 11, 2006 8:25 am
by Dino
ok, but
do i have to raise the value or decrease with bigger inj. (Benz 420ccm). How is the logic of that value. Higher value = higher latency or the other way round?
I think you use also the Benz injectors. What value would you recommend?
Posted: Tue Jul 11, 2006 2:40 pm
by Bernardd
higher value=longer opening time
those injectors have a latency of 4D from what I've seen.