Page 1 of 1
Homemade Twinscroll manifold
Posted: Tue Sep 21, 2010 2:07 am
by Mads B (dk)
Re: Homemade Twinscroll manifold
Posted: Tue Sep 21, 2010 3:30 pm
by PL
Brilliant - I love it!!
I've done a few manifolds from steampipe bends and it works great. Albeit a little time consuming...
What turbo are you using?
PL
Re: Homemade Twinscroll manifold
Posted: Tue Sep 21, 2010 7:28 pm
by kenbam
Re: Homemade Twinscroll manifold
Posted: Wed Sep 22, 2010 1:36 am
by Mads B (dk)
PL wrote:Brilliant - I love it!!
I've done a few manifolds from steampipe bends and it works great. Albeit a little time consuming...
What turbo are you using?
PL
Im runing a cheap china T3/T4 "trim O" @ 1.6bar
Re: Homemade Twinscroll manifold
Posted: Wed Sep 22, 2010 8:43 am
by skylinegtrhr
Nice project we have FR TS GT3076 kit on SR and results are great , we have 0,7 bar on 1800 rpm on dyno
but You should put thermo coating on manifold and DP or You are going to have very high under bonnet temperature.
And make extra braces for turbo as You have down mount which "like" to make cracks on manifold from weight of turbo and vibration of engine.
And if You can go for full TS set up with two WG ...
Re: Homemade Twinscroll manifold
Posted: Sun Apr 03, 2011 12:15 am
by Torque
Mads B (dk) wrote:
Im runing a cheap china T3/T4 "trim O" @ 1.6bar
Are these China Turbos any good at all?
I saw many of them @ EBAY ...
Re: Homemade Twinscroll manifold
Posted: Mon Apr 04, 2011 6:12 am
by Mads B (dk)
this one is okay and the most journal bearing turbos are..... but the china roller bearing ones are shit
Re: Homemade Twinscroll manifold
Posted: Sun Aug 14, 2011 10:24 pm
by Mads B (dk)
1.8bar boost (on the road i have fullboost at 4500-4700rpm)