Page 1 of 1
VTC (VCT) Logging / Display in Consult Vehicle Display
Posted: Tue Oct 05, 2010 7:01 pm
by Torque
I was not able to display the status of the VTC (VCT) in the consult vehicle display.
I think I have enabled all the consult flags, but the display came not on.
How do you do this?
In addition it would be very nice to log the VTC status in the log recorder as well.
(Did not find it in the logable items list)
Many thanks,
Andrew
Re: VTC (VCT) Logging / Display in Consult Vehicle Display
Posted: Sun Oct 10, 2010 12:20 am
by Matt
Check if it comes on in stream mode with Consult Digital Register 3 ticked. It should come up in tuner mode afterwards (think there is a bug there since only just noticed that this week)
Re: VTC (VCT) Logging / Display in Consult Vehicle Display
Posted: Sun Oct 10, 2010 7:59 am
by Torque
OK ... will try when back in the garage next week ..
Re: VTC (VCT) Logging / Display in Consult Vehicle Display
Posted: Wed Nov 17, 2010 9:47 am
by Torque
Hi ...
I could not activate the VTC logging....
I tried stream mode as well, but this mode makes Nistune go nuts.
(got very strange readings then)
viewtopic.php?f=8&t=1746&p=12101#p12101
Re: VTC (VCT) Logging / Display in Consult Vehicle Display
Posted: Mon Dec 06, 2010 9:33 am
by Torque
Hi!
I got it to work ... however I was thinking VCT would come up as a unit in the logger itself.
(so I would get an on/off graph)
But It works fine by bringing up the Consult Display.
Re: VTC (VCT) Logging / Display in Consult Vehicle Display
Posted: Mon Dec 06, 2010 3:04 pm
by Matt
only gauge items come up in the logger. anything which is a switch (neutral, tps, start etc) is not a register in itself, but you can still see in the consult display window. Yeah I could see VCT showing up on the bench last week during playback