Nistune Forums

Posted: **Tue Jan 25, 2011 11:43 am**

Hi have a Type 1 in at the moment that was tuned a few years back in SA it has a 6 pin green connector (x3) on it and the usual x1 and X2 connectors.

It came in with no usb connected to x2 so i fitted one, but nistune wont recognise the ecu.. is there a jumper i need to solder on these older boards to enable USB or is it locked?

Posted: **Tue Jan 25, 2011 1:14 pm**

it should work still with the USB connector

Make sure pins are correct way around otherwise we can send you another connector for it

Posted: **Wed Jan 26, 2011 7:15 pm**

Got it sorted i had to back date my drivers to the original setup i had a 2odd years back then it talked fine... odd

Nistune Forums

Got an old type 1 in here that had no usb, now wont connect

Got an old type 1 in here that had no usb, now wont connect

Re: Got an old type 1 in here that had no usb, now wont connect

Re: Got an old type 1 in here that had no usb, now wont connect