A couple of issues :: v. 10.12
Posted: Sat Sep 24, 2011 1:11 pm
1.) Sometimes the nistune won't connect. I can initially connect, but then it will drop the connection after some time and if I try to connect it says it won't connect, even though it's still on the same com port. I have to close nistune, turn the ignition off, leave it off for about a minute, then put power to the ignition and connect again and it works.
2.) Same as 1, but it also disconnects when starting the car (expected), but I can't reconnect after the car is started which makes logging impossible.
3.) I frequently get a bluescreen with the error: multiple_irp_complete_requests. This is an HP elitebook 8440p, which is running 64-bit version of Windows 7 Enterprise.
Note: I am using a real consult device and then I have a Dynex serial to USB converter from it to the laptop.
I am actively working to find a solution on my end and will update if I am able to figure it out.
2.) Same as 1, but it also disconnects when starting the car (expected), but I can't reconnect after the car is started which makes logging impossible.
3.) I frequently get a bluescreen with the error: multiple_irp_complete_requests. This is an HP elitebook 8440p, which is running 64-bit version of Windows 7 Enterprise.
Note: I am using a real consult device and then I have a Dynex serial to USB converter from it to the laptop.
I am actively working to find a solution on my end and will update if I am able to figure it out.